JvG Communications - PD0JAN in Nijmegen.

LDG AT-600Pro Universele auto antenne tuner. 

Is op voorraad.

Prijs: € 360,=

Garantie: 2 jaar 

Specificaties: 

• 600 Watts SSB and CW, 300W RTTY (250 watts on 6M
• Easy to read LED bar graph display for RF power, SWR and status
• 4,000 memories for instantaneous band changing
• Two position antenna switch with memories for each position
• Tuning time: 0.5 to 6 seconds full tune, 0.1 second memory tune
•  Built in frequency counter for memory operation
•  Frequency coverage: 1.8 to 54.0 mhz
• Tunes 6 to 800 ohm loads (16 to 150 ohms on 6M
• For Dipoles, Verticals, Vs, Beams or and Coax Fed Antenna
•  Includes DC power cable, Icom interface cable and coax jumper
•  Power requirements: 11 to 16 volts DC at 750 mA max during tuning
•  Enclosure: 10.5D x 8.5W x 2.5H inches

Bijzonderheden:
Verzenden geen probleem, verzendkosten € 8,=

LDG AT-897 Antenne tuner.

Is op voorraad.

Prijs: € 205,= 

Garantie: 2 jaar

Specificaties:

Microprocessor controlled
2000 fast memories arranged by frequency
Switched L tuning network
Mounts on the side of the Yaesu FT-897 with four M3-0.5x10 screws (included)
Dual function tune control button
Continuous coverage 1.8 to 54 MHz
Power rating HF: 0.1 to 100 Watts
Latching Relays
CAT control at 4800 baud with extra CAT Port
Tuning time: 1 to 7 seconds, 4 average
Antenna impedance: 6 to 800 Ohms (Approximately up to 10:1 SWR, 3:1 on 6M)
Tunes nearly any coax fed antenna. Use optional Balun for long wires.
Power requirements: 11 to 14 volts DC @ 300 milliamps during tune
Operating voltage supplied via the CAT Port (cable supplied with tuner)
Enclosure sizes: 11.5D x 3.25H x 1.5W (measured in inches)

Bijzonderheden:
Verzenden geen probleem, verzendkosten € 8,=

Download de folder:  LDG AT897

LDG KT-100 Auto antenne tuner.
Speciaal ontwikkeld voor de Kenwood transceivers

Is op voorraad.


Prijs: € 190,=

Garantie: 2 jaar

Specificaties:

• 0.1 to 125 watt power range (SSB and CW), 100W on 6M.
• 2000 memories for instantaneous band changing.
• Controlled from Kenwood Tuner button on radio. Powered from Kenwood radio.
• Works with any Kenwood radio that is AT-300 compatible.
• Partial radio list: TS-50, TS-480 (not HX), TS-570, TS-690, TS-850, TS-870, TS-2000.
• Tuning time: 0.1 to 6 seconds full tune, 0.1 seconds memory tune.
• 1.8 to 54.0 MHz coverage. Built-in frequency sensor.
• Tunes 6 to 1000 ohm loads (16 to 150 on 6M), 6 to 4000 ohms with optional 4:1 Balun.
• For Dipoles, Verticals, Vs, Beams or any Coax Fed Antenna.
• Optional external Balun allows tuning of random length, long wire or ladder line fed antennas.
• Includes Kenwood interface cable and coax jumper. Ready to use right out of the box.
• Small Size Enclosure: 6.5L” x 6.5W” x 1.5H”.

Bijzonderheden:
* Noot voor het gebruik met een Kenwood TS-480HX; Kenwood heeft de TS-480HX zo geprogrammeerd dat wanneer een externe
   tuner gedetecteerd wordt, het RF vermogen wordt beperkt tot 100watt. Zover bekend is, is er geen modificatie voor beschikbaar.
   De LDG KT-100 kan met de Kenwood TS-480HX verbonden worden maar het RF vermogen zal nooit meer worden dan 100watt.
   LDG adviseerd voor de Kenwood TS-480HX de LDG AT-200Pro te gebruiken als het volle RF vermogen van 200watt gewenst is.

* Note for use with TS-480HX: Kenwood has programmed the TS-480HX so that if it detects an external tuner, it will limit the RF power
   to 100 watts. It is not modifiable as far as we know. While the KT-100 can be connected to the TS-480HX, the radio will never transmit
   more than 100watts. We would normally recommend the LDG AT-200Pro for the TS-480HX if the full 200 watts is required.

Verzenden geen probleem, verzendkosten zijn € 8,=

LDG YT-450 Auto antenne tuner.
Tuner is speciaal ontwikkeld is voor Yaesu FT-450 & FT-950

Is op voorraad.
 
Prijs: € 235,=

Garantie: 2 jaar

Specificaties:

• RF Power: 1 to 100 watts SSB, CW and digital modes.
• Latching relays for ultra low power consumption
• Built-in CAT/Power interface for FT-450 and FT-950 radios.
• CAT thru port for computer control of radio. 4800 baud.
• 2000 memories sorted by frequency.
• 1.8 to 54 MHz coverage (continuous coverage for MARS)
• Tunes 4 to 1000 ohms. (16 to 150ohm on 6M)
• SO-239 in and out connections for dipoles, verticals, beams, G5RV, OCF, Cobra, ect.
• Dimensions: 7.0”L, 7.8”W, 2.0”H. Weight: 2 pounds
• Includes 1.5 foot CAT/Power interface cable and 1 foot coax jumper.

Bijzonderheden:
Verzenden geen probleem, verzendkosten zijn € 8,=